EyeLink II Scene Camera User Manual
©
2004-2007 SR Research Ltd.
21
Video Input: S-IN (if S-Video In is used for the scene camera input);
or V-IN (if V-In is used.)
Figure
3-5: Wiring Diagram for Scene Camera Option.
3.3.2 Setting up the Digital Video Converter
The following steps should be followed to set up the Digital video (DV) converter
box:
•
The “S-OUT” of the AVT-3170 overlay box should be connected to “S
VIDEO IN” on the front of the Canopus ADVC converter box (or the “V-
OUT” of the overlay box to the “VIDEO IN” of the DV converter if a
composite video cable is used).
•
Connect the IEEE 1394 firewire cable between the Canopus ADVC
converter box and the display computer. If you use a laptop as the
display PC, plug the larger 6-pin end into the back of the box and the
smaller 4-pin end into the computer.
•
If you are using the ADVC 100 Converter box or you are using a laptop
as display PC, please plug in the AC adapter of the DV converter box. If
you use the ADVC 55 or ADVC 110 Converter box and have a desktop as
the display PC, you may use the 6-pin-to-6-pin 1394 firewire cable
without the optional AC adapter.
Note: When you connect or remove the
DV cable, please make sure the power of both PC and the DV converter, if
used, are off. The DV converter may be damaged because of a power surge.
3.3.3 Recording Audio Data
Version 1.0 of the SceneLink application supports recording of audio data with
an ADVC 100 or 110 converter (ADVC 55 is not supported). To do this, the
user should connect the microphone to an amplifier; the output from the
amplifier should then be connected to the L/R RCA jack at the front (or the
“Audio In” minijack at the back, depending on the cable and converter used). In
addition, the user should check for the settings of the mode switch selectors at
