SPM leonova emerald, Руководство пользователя

Страница: 52 / 170

B:18
General measurement functions
B
3
Press F1 ’Measure all’ to start measuring. You will
be prompted to connect transducers and/or input
manual data.
When a RPM result is saved the value will be
transferred to the subsequent measurement
points under the same component. If a measuring
point under the component has a different ’Max
RPM’ value this RPM value will be recalculated on
the basis of the measured measurement point.
Conditions to enable this feature:
- RPM is available as technique
- There is a saved RPM value (may be a download-
ed preset value from Condmaster or a measured
value)
- None of the other measuring techniques have
”Measure RPM simultaneously” enabled
- RPM can not be set as USER (user input) in the
channel settings for ’Measure all’.
To use the RPM from the previous measuring point,
untick ‘Measure RPM’ (1) by pressing F3 in the first
’Measure all’ dialog box.
Press ’Edit’ (F1) in the ‘Measuring point data’
window to change the RPM settings if values are
outside the limits. New settings will be transferred
to Condmaster when uploading the round.
All measured assignments are displayed during meas-
urement (2). When a measurement is completed for
a particular assignment its status bar is green for a
few seconds before the assignment disappears from
the list. If an error occurs during the measurement
of an assignment its status bar becomes red (e.g.
TLQ error).
When a measuring assignment is completed it disap-
pears from the list. When all assignments on the list are
compleded the measuring window closes automatically
and the display will show ’All techniques measured!’.
Press ENTER to go to next measuring point.
Press F2 ‘View summary’ to see the results of all
measurements just carried out (3).
To toggle between measurement results, use the UP/
DOWN arrow keys. From ‘View summary’, measure-
ment results can be erased and measured again.
2
1