SPM leonova emerald, Руководство пользователя

Страница: 156 / 170

F
F:6
Rotor balancing
Default transducer for balancing measurement
The ‘Registration of vibration transducers’ proce-
dure is described in Part A of this manual. Before
starting vibration measurements, make sure that
the vibration transducer you are using with your
Leonova is properly registered, configured and
selected.
To select and edit a transducer, press the MENU
key and select ‘Settings’ > ‘Vibration transducers’.
Use the arrow keys to mark a transducer on the
list (1) and press F2 (‘Edit’) (2) to open and view
its data.
To edit transducer data, mark the setting you want
to change and press F2 (‘Edit’).
The nominal sensitivity of a vibration transducer
SLD144 is 10 mV/m/s
2
. The actual sensitivity of the
individual transducer is written on its calibration
card. This data should always be input in the
transducer register (3). When several transducers
are in use, they should be marked (e.g. with serial
number) to assure that the readings are calibrated.
While in the ‘Vibration transducers’ menu, press
the F4 key (‘Default transducers’) (4), then select
‘Balancing’ (5) and press ‘ENTER’. Choose which
transducer to be used as default transducer for
balancing measurements by pressing ‘ENTER’ to
get to the list (6). Use arrow keys to choose from
the list and press ‘ENTER’ when ready. Finish
the selection of default transducer by pressing
‘BACK’ (Leonova automaticlly updates the choice
of default transducer).
Transducer line quality, TLQ
Leonova is automatically testing the quality
of signal transmission between transducers of
type IEPE and instrument before measurement.
The unit of measure is voltage (Bias). Accepted
values depends on transducer settings. Not
acceptable values generates an error message.
1
2
3
4
5
6