Spirax Sarco RIM20, Инструкция по установке и обслуживанию, Страница: 107 / 132

IM-P198-05 MI Issue 2 107
Factory Defaults
Reset factory defaults. If you change this to Yes and press Enter,
all the factory configuration is lost and you must reconfigure the
entire program. Consult the factory before performing this process,
it is required only in very rare cases.
Config Code Factory use only.
Test Pulse Out
Force totalizer pulse. Set to Yes and press enter to send one pulse.
Very useful to test totalizer counting equipment.
Test Scaled Freq
Enter a frequency value in order to test the scaled frequency output.
Return to 0 to stop the test.
Output Type Factory use only.
Calibration mode Factory use only.
A2D Ref. Resistor Factory use only.
Pressure Cal Current
Calibration value for the electronics and pressure transducer
combination. Consult Factory for value.
Pressure 9Cs
Nine pressure coefficients unique to the pressure transducer. Use
the RIGHT ARROW to access all nine coefficients.
Press. Max psi = Based on installed sensor.
Press. Min psi
0 psi aRTD1. Press the RIGHT ARROW to access:
Ro = RTD resistance at 0 °C (1000 ohms).
A = RTD coefficient A (.0039083).
B = RTD coefficient B (-5.775e-07).
RTD1 Max Deg. F = 500
RTD1 Min Deg. F = -330
RTD2 Second RTD configuration, for special applications only.
Correction Pairs
ft3/sec (1 through 10)
%Dev. (1 through 10)
Roughness Factory use only.
Force Recal? Factory use only.
Min. Delta H - Energy
EM meters only
Sets the deadband for totalization to begin. Must be greater than
this number (1 default) to initiate the totalizer.
Init Displ. (sec)
Enter a value in seconds to initialize the display every xxx seconds.
Enter a value of 0 to disable initializing the display.