F1 F2 F3 F4
F1 F2 F3 F4
F1 F2 F3 F4
When the selection is correct, press
OK (F4)
to accept. The display will
then go through the same process for all 4 lines of the 2 programmable
displays (DSP1L1, DSP1L2, DSP2L1 and DSP2L2).
After the last line of display 2 is accepted, the display will show the
following menu:
This menu allows you to alternate between menu display 1 and 2 every
few seconds.
Selections are: On or Off
Press
OK (F4)
to accept selection.
Press
EXIT (F4)
repeatedly until “Normal Mode” is seen briefly to exit the
programming mode.
Password
There are two user level passwords, only
Level 1
is programmable and
gives access to all the normal settings. The second password is used to
allow access to calibration factors and should normally never be changed
unless advised by the Spirax Sarco Technial Support, or to set a new
password in the event that the user forgets the
Level 1
password.
Default
Level 1
password is “1234”, and
Level 2
password is “9111”.
The
Level 1
programmable password can be disabled by setting it to “0”.
From the base programming menu press
DSP (F3)
to select the display
menu:
ALTERNATE = Off
NXT OK
SET PARAMETERS
I/O FLO DSP EXIT
DISPLAY/PASSWORD
DSP IR PSW EXIT
38
Operation: Programming
Programming
Using
the Local Display