ST2516 Series Operation Manual
13
3.2.1
File Manage
1)
Touch
FILE
, the following soft keys will be displayed:
File manage: Touch this soft key to enter into the file manage page.
Screen copy: Touch this key to save the current screen page to a U disk. If no U disk is found,
this function will be disabled.
Save Data OFF: Touch this key, this key will turn to <Save Data ON> and each measurement
result will be continuously saved to the .CSV file in U disk. Before a U disk is inserted, the
save function will be disabled. Press the key again, this key will turn to <Save Data OFF> and
the measurement result will not be saved. When switching between ON and OFF once, a
new .CSV file will be created in a U disk. The measurement data can be analyzed by opening
the file through the computer.
2)
Refer to 4.2 for more details about
FILE MANAGE
.
3.2.2
Tools
Touch
<TOOLS>
, the following soft keys will be displayed.
DISP (ON/OFF):
ON is to display the measurement result and OFF is not to.
BEEP (NG/GD/OFF):
NG: The beeper will sound when the measurement result is not
consistent with the setting value. GD: The beep will sound when the measurement result
conforms to the setting value. OFF: Turn off the beeper.
COUNT (ON/OFF):
ON
：
Start count; OFF: Stop count.
COUNT CLEAR
：
Clear the count numbers of TOT, IN, HI and LO and start count from zero.
DISP MODE NORMAL:
press the key,
DISP Mode DEV
will be displayed. The value of
deviation
△
will be displayed in the main display interface and the display range is
-99.9~999.9%. Press the key again and
DISP MODE NORMAL
will be displayed.
NOTE:
△
={( measured resistance value - nominal resistance)/ nominal resistance} x 100%
3.2.3
COMP (ON/OFF)
COMP (ON/OFF): ON
indicates the compare function has been turned on. Only when the
compare function is in ON mode, count and beep function can be enabled.
OFF
is to turn off this function.
3.2.4
Compare Mode and SETTINGS of ABS & Percent Error
You can set the compare mode and concerned values by touching the screen or pressing
keyboard. There are two compare modes: ABS and %.
Compare modes:
1)
ABS (high and low limits)
In this mode, you can set low and high limits. The instrument will take comparison between the
