
- 42 -
SORHEA
G-WALL
8) Move switch 1 to “OFF” to deactivate the buzzer
9) Close the cover of the Control Unit (UG).
7
SETTINGS
The different functions allow to adapt the G-Wall system to all kinds of installations.
The available settings in the Control Unit (UG) are:
Manual setting of the sensitivity of all sensors on the same zone.
Setting the number of events before alarm.
7.1 Procedure to enter into setting mode.
1) Identify the zone where the setting must be adjusted. (zone 1 or zone 2)
2) Move the switch to “ZONE 1” or “ZONE 2” to enter configuration mode for the Control Unit
(UG) and to configure the cable selection (zone 1 or zone 2).
The buzzer will beep twice to confirm entry into configuration mode.
The red LED starts blinking.
3) The buzzer beeps once and the red LED turns off. Configuration is finished.
If after 2 minutes, the buzzer still does not beep and the red LED is still blinking, refer to §9
MAINTENANCE.