Sony UP-DR200, Руководство по обслуживанию, Страница: 31 / 102

1-25
UP-DR200
10 5,6
1. Remove the output tray and scrap receptacle.
2. Check the remaining amount of print paper.
3. Open the ribbon door, and remove the ribbon tray.
4. Remove the ink ribbon, and replace it with the clean-
ing ribbon.
5. Load the ribbon tray into the printer, and close the
ribbon door.
After the printer initializes, thermal head cleaning
starts automatically.
When thermal head cleaning finishes, the following
message appears.
To continue with roller cleaning, proceed to step 6.
To end the cleaning process here, press the
7
button.
The print paper used will be cut and ejected.
Proceed to step 11.
6. Press the
7
button.
About 20 cm of paper is ejected automatically, and the
following message appears.
7. Remove the paper from the back side of the cleaning
sheet (the side without illustrations).
n
Be careful not to remove the paper from the wrong
side of the sheet.
8. Refer to the following illustrations according to the
width of your paper roll, determine the orientation of
the cleaning sheet, and affix the sheet evenly onto the
paper 5 cm away from the edge.
When using the 2UPC-R203/R205 series printing pack
Affix the cleaning sheet vertically.