11
Function Setup
Cha
p
te
r 1
Us
er
Gu
ide -
R
11
0
Function Setup
Just as in film projection, there are a number of issues
related to the configuration of the Digital Cinema projector
for the content being presented. One easily called to mind
in film is the aperture plate which is selected based on the
image format. Because the Digital Cinema system can
present content of varying formats the settings are much
more complex. The majority of these are set using the SRX
Controller
1
application and stored in the FUNCTIONs (F1
through F7). However, some settings may require
adjustment of a more immediate nature. These are
available to you on the FUNCTION SET-UP screen.
Function Setup Controls
are available on the
FUNCTION SETUP
pane. To access the
Function Setup pane, tap
Menu
and then tap
Function Setup
. The
FUNCTION SET-UP
pane appears.
Below the Current
Function indicator select
the target FUNCTION
using Change
FUNCTION. After
selecting the FUNCTION
(F1, F2, etc.), you can set
the LAMP POWER and
adjust various image
related settings (ADJUST PROJECTOR). The settings are
stored in the selected FUNCTION as they are made for
later recall by selecting the specific FUNCTION.You can
also select from a number of Test Patterns for projection on
the auditorium screen to assist in alignment.
Caution:
Any changes made to adjustments on the
FUNCTION SET-UP pane appear as they are made and
will be reflected in the settings returned the next time the
indicated FUNCTION is selected on the Projector Control
panel or recalled as part of a SPL where the included CPL
are associated with a FUNCTION.
Select “Target” Function Key
Prior to making any adjustments to settings appearing on
the FUNCTION SET-UP pane select the desired Function
Number (if necessary).
To select the Function, tap
Menu
, tap
Function Setup
,
and then tap
Change FUNCTION.
The CHANGE
FUNCTION popup appears.
To select the FUNCTION
to be applied to the
projector, tap the target
FUNCTION
(F1, F2,
etc.).
The Projector settings
will change, e.g., Focus,
Zoom, Lamp Power, etc.,
to reflect the stored
settings for the selected
FUNCTION. The Current Function indicates the new
selection.
Note:
It may take some seconds for the process to
complete as some adjustments are mechanical in nature,
e.g., Zoom, Focus, etc.
MAKE SURE THAT THE CORRECT FUNCTION, e.g.,
F1, APPEARS IN “CURRENT FUNCTION” BEFORE
MAKING ANY ADJUSTMENT ON THIS SCREEN.
THERE IS NO “UNDO”
AND THE CHANGES YOU
MAKE WILL EFFECT THE PRESENTATION
EVERYTIME THE INDICATED FUNCTION IS
RECALLED USING EITHER THE PROJECTOR
CONTROL SCREEN OR WHEN THE FUNCTION IS
ASSOCIATED WITH A CPL AS PART OF A SHOW
OR SPL.
1.The SRX Controller exercises direct control over
the projector and therefore should not be used at the
same time the Projectionist Terminal or SMS Control-
ler is in operation.
Tap Menu
Tap
Function Setup
Pop-Up Menu
Change FUNCTION
Current Function
Current FUNCTION
Tap to Select
Содержание LSM-100
Страница 27: ...23 Power ON OFF Chapter 1 User Guide R110 ...
Страница 53: ...Sony Corporation ...
