Sony DVCAM DSR-50, Руководство по обслуживанию, Страница: 203 / 285

5-73
27. E-E Color Level Adjustment (VD-28 Board)
Mode E-E
Signal Color bar (NTSC: with 7.5% setup)
(CAMERA input) (Note)
Measurement Point VIDEO OUT 2 terminal (75
Ω
terminated)
Measuring Instrument Vectorscope (NTSC: 7.5% setup
mode)
Adjustment Page E
Adjustment Address CA, CB
Specified Value From the center of mark on the
vectorscope, each luminance point
must satisfy the following:
Level: ± 5%
Phase: ± 3º
Note1: Set “CAMERA” mode with INPUT SELECT switch
Adjusting method:
1) Select page: 0, address: 01, and set data: 01.
2) Adjust the burst luminance point to the specified position using
the PHASE and GAIN knobs of vectorscope.
3) Change the data on page: E, addresses: CA, CB and adjust so
that each luminance point positions at the mark on the
vectorscope.
4) Press the PAUSE button of the adjustment remote commander.
5) Select page: 0, address: 01, and set data: 00.
R
M
G
Y
L
Burst
G
C
Y
B
For PAL model For NTSC model
Fig. 5-3-33
R
–R
M
G
–M
G
Y
L
–Y
L
Burst
–Burst
G
–G
C
Y
–C
Y
B
–B