Sony DVCAM DSR-50, Руководство по обслуживанию

Страница: 192 / 285

5-62
11. Color Level Adjustment with 0% Setup
(VD-28 Board)
Mode Playback
Signal Arbitrary
Measurement Point VIDEO OUT 2 terminal (75
Ω
terminated)
Measuring Instrument Vectorscope (NTSC: 0% setup
mode)
Adjustment Page E
Adjustment Address A1, A2
Specified Value From the center of mark on the
vectorscope, each luminance point
must satisfy the following:
Level: ± 5%
Phase: ± 3º
Note: This is the tracking adjustment in relation to “SC_V Phase
Adjustment”.
Adjusting method:
1) Select page: 0, address: 01, and set data: 01.
2) Select page: 3, address: 0C, set data: 01, and press the PAUSE
button of the adjustment remote commander.
3) Only for NTSC model, set the vectorscope to the 7.5% setup
mode.
4) Adjust the burst luminance point to the specified position using
the PHASE and GAIN knobs of vectorscope.
5) Only for NTSC model, set the vectorscope to the 0% setup
mode.
6) Change the data on page: E, addresses: A1, A2 and adjust so
that each luminance point positions at the mark on the
vectorscope.
7) Press the PAUSE button of the adjustment remote commander.
8) Select page: 3, address: 0C, set data: 00, and press the PAUSE
button.
9) Select page: 0, address: 01, and set data: 00.
12. SC_V Phase Adjustment (VD-28 Board)
Mode Playback
Signal Arbitrary
Measurement Point VIDEO OUT 2 terminal (75
Ω
terminated)
Measuring Instrument Vectorscope (NTSC: 0% setup
mode)
Adjustment Page E
Adjustment Address A8
Specified Value From the center of mark on the
vectorscope, each luminance point
must satisfy the following:
Level: ± 5%
Phase: ± 3º
Note: This is the tracking adjustment in relation to “Color Level
Adjustment with 0% Setup”.
Adjusting method:
1) Select page: 0, address: 01, and set data: 01.
2) Select page: 3, address: 0C, set data: 01, and press the PAUSE
button of the adjustment remote commander.
3) Only for NTSC model, set the vectorscope to the 7.5% setup
mode.
4) Adjust the burst luminance point to the specified position using
the PHASE and GAIN knobs of vectorscope.
5) Only for NTSC model, set the vectorscope to the 0% setup
mode.
6) Change the data on page: E, address: A8 and adjust so that
each luminance point positions at the mark on the
vectorscope.
7) Press the PAUSE button of the adjustment remote commander.
8) Select page: 3, address: 0C, set data: 00, and press the PAUSE
button.
9) Select page: 0, address: 01, and set data: 00.
R
M
G
Y
L
Burst
G
C
Y
B
Fig. 5-3-18
For NTSC model For PAL model
R
–R
M
G
–M
G
Y
L
–Y
L
Burst
–Burst
G
–G
C
Y
–C
Y
B
–B