Sony CSM-100BF, Руководство по установке

Страница: 51 / 168

4-33
CSM-200
(b) M4 x 14
(b) M4
x
14
(d) M4 x 8
(c) M4 x 25
(a) M4 x 14
Washer (4.5 x 15 x 1.5)
Washer
(4.5
x 15 x 1.5)
X pulley assembly
(top)
X tension assembly
X belt
Six gear teeth Six gear teeth
X belt holder bracket
X belt holder
(2) Confirm that the X belt (top) is not twisted. After confirming that, align the six gear teeth at both
ends of the X belt (top), with the X belt holder bracket and with the fixing belt (X) that were
removed in step (11) of “14. Removing the X Belt”. Then, secure the X belt (top), the X belt
holder bracket and the fixing belt (X) by tightening the six hexagonal head cap bolts (M3
x
12),
the six spring washers and the six washers.
(3) Install the washer (4.5
x
15
x
1.5) and the hexagon head cap bolt (M4
x
14) (a) removed in step
(6) of “14. Removing the X Belt” at the same positions of the end console.
(4) Install the X belt (top) around the upper pulley of the synchro shaft. Secure the X pulley
assembly (top) using the two hexagonal head cap bolts (M4
x
14) (b) and the two washers (4.5
x
15
x
1.5), to fix it to the end console (the console that is lastly installed).
n
Tighten the hexagonal head cap bolts (M4
x
14) (b) while pulling the X pulley assembly in the
direction of increasing the belt tension.
(5) Rotate the hexagonal head cap bolt (c) of the X tension assembly, that is removed in step (4) of
“14. Removing the X Belt”, fully in the direction of loosening the spring. Then install it in the
end console (the console that is attached last) by reversing the steps of removal.