Sony CCD-M8, Руководство по обслуживанию

Страница: 150 / 166

2-3-3 1 .
Tension Regulator Position Adjustment
1 . Removal
1 ) B y referring t o 2- 1 - 1 and 2-1 -2. remove cassette arm
assembly and LS cassette compartment assembly.
2.
Adjustment
I ) Turn and set a cassette tape and run the
tape. (See Fig. 2- 1 -4)
2) I n tape running state. confirm whether the arrow marked
Q
point is positioned at the point (arrow mark © )
I
/3
within the thickness of LS guide
f)
or not. ( See
Fig. 2-46)
3) When it is not at the specified position. remove the cassette
and perform the adjustments described in after step 4).
4) Loosen screw 8 .
5) I f TG-1 arm assembly
O
is within the inner side than the
specified position. shift the tension regulating band plate
0
slightly in the direction of arrow
(i.
If it is in the outer
side. shift it slightly in the direction of arrow @) and secure
it with screw
8 .
( See Fig. 2-47)
Notes:
1
I Use a cassette tape which has been forwarded to about
the middle section.
2 ) When performing step 2 ) , the cassette tape should be
removed in advance.
3. Installation
By referring to 2- 1 - 1 and 2-1 -2. install cassette arm
assembly and LS cassette compartment assembly.
-
63
-
0 TG- 1 arm assembly
•
LS guide
Tape
b = 1/3a
Fig. 2-46
8 Screw
3
0
Tension regulating band plate
Fig. 2-47