Sony CCD-M8, Руководство по обслуживанию

Страница: 137 / 166

2-3- 1 7. Phase Adjustment
1 . Removal
1 )
By referring to
2- 1 - 1
and
2- 1 -2.
remove cassette arm
assembly and LS cassette compartment assembly.
2)
By referring to
2-3- 10,
remove LS chassis.
3)
By referring to
2-3-14,
remove
TG-4
base assembly and T
G-
5
base assembly.
4)
By referring to
2-3-25.
remove drum assembly. (See Fig.
2-
30)
2. Adjustment
I)
that it has been turned into BLANK after
GUIDE LOAD mode.
2)
Adjust the positions of the respective holes ofloading slider
T
assembly
f)
.
loading slider S assembly
8 .
and the
mechanical chassis. and then insert a rod O of
approximately
I
mm in diameter into the holes.
3) Adjust the position of the hole of LS gear C assembly and
the position of the hole of the mechanical chassis. and
insert rod 0 of aproximately
I
mm in diameter into the
holes.
0 Rod
0
LS gear C assembly
4)
Adjust by turning loading gear M 0 so that the mark
on it comes to the loading gear S 0 side. as shown in Fig.
A
5)
Remove lock washer
fl)
and LS gear A
0.
and adjust so
that both holes of loading slider T assembly
f)
and LS
gear A
0
come on the same straight line as shown in Fig.
B, and preform installation.
6) Install lock washer
fl) .
Note:
Be sure to confirm that lock washer
fl)
is set completely in
the groove of the shaft.
3. Installation
I )
By referring to
2-3-25.
install drum assembly.
2)
By referring to
2-3-14.
install
TG-4
base assembly and
TG-5
base assembly.
3)
By referring to
2-3-10.
install LS chassis assembly.
4) By referring to
2- 1 - 1
and
2- 1 -2.
install cassette arm
assembly and LS cassette assembly.
0 Loading gear S 0 Loading gear
M
Fig.
B
Fig. 2-30
-
50
-