Sony CCD-M8, Руководство по обслуживанию

Страница: 134 / 166

2-3- 1 4. TG-4 Base Assembly and TG-5 Base Assembly
1 . Removal
1 )
By referring to
2- 1 - 1
and
2- 1 -2,
remove cassette arm
assembly and LS cassette compartment assembly.
2)
By referring to
2-3- 1 0.
remove LS chassis assembly.
3)
Set into GUIDE
mode and remove TG-4 base
assembly
0
and TG-5 base assembly
f)
from the groove
of the drum base.
4) Turn pin
0
ofTG-4 base assembly
0
in the direction of
arrow O and remove from notch 8 . (See Fig.
2-25)
5)
Remove pin
0
from the hole of notch 8 .
6)
Remove TG-5 base assembly
f)
from notch 0 by
moving it in the direction of arrow
0
(See Fig.
2-26)
7)
Remove TG-5 base assembly
f)
from pin
0 .
(See Fig.
2-
27)
Note:
Be sure not to contact with the guide section marked with *.
2 . Installation
I )
Insert pin
0
into the hole of TG-5 base assembly.
Fig. 2-25
2)
Insert TG-5 base assembly
f)
beneath notch
f)
by
moving it in the direction of arrow B.
3 )
Insert pin
0
of TG-5 base assembly
0
into the hole of
notch O
4) Set pin
0
of TG-4 base assembly
0
into notch
8
by
turning it in the direction of arrow © .
5)
Confirm that the TG-4 base assembly
0
and TG-5 base
assembly
f)
have been installed in the states as shown in
Fig. C respectively.
6)
Set TG-4 base assembly
0
and TG-5 base assembly
f)
into the groove of the drum base while slowly turning
BLANK after GUIDE LOAD mode. If the position are
not matched. the assembly is caught by the entrance of the
groove and, accordingly, it may be unable to move.
Therefore. be sure to set it into the groove while matching
the positions very carefully.
7) By referring to
2-3- 1 0,
install LS chassis assembly.
8) By referring to
2- 1 - 1
and
2-1 -2.
install cassette arm
assembly and LS cassette compartment assembly.
Fig. 2-26
*Guide section
f)
TG-5 base assembly
I
*Guide section
O TG-4 ba"
Fig.
C
Fig. 2-27
-47-