Sony BVH-2000, Руководство по эксплуатации и обслуживанию

Страница: 254 / 505

Address AOIOH
TEST
When
is set test
z
o
I-
«
~
a:
o
LL
Z
TAPE
When
either the tape not threaded
through the tape sensor or the tape is completely
wound up on the S or T reel, bit 5 is set to "1". In such
a case, the VTR will be forcibly placed into the STOP
mode,
and the message HTAPE OUT" will be
displayed on the type 2 or 3 control panel.
SERVO MISSING
If to the
the front is not
bit set to
a case, STOP button blink,
possible to carry out the normal
operation.
BIT3: TIP ERROR
When one of the following errors occurs, bit
3
will
be set to
"1".
I n such a case, the VTR will be forcibly
placed the STOP mode, the SYSTEM alarm
lamp front light up buzzer
will
1. becomes
of the or tension
w
U
>
a:
w
(f)
<r
arm.
2. When either the capstan DME is damaged or
the tape slips owing to insufficient
pressure of
the pinch roller.
3. If the T reel turns freely because of incomplete
tape winding on the T reel, or if the S or T reel
is damaged.
timer
above
RL-12 Board
D5 D4 D3
D2 Dl DO
ERROR
1 1 1 0 0 0 T-Ree1 Tension
1 1 0
1
0
0
S-Reel Tension.
1 1 0
0
1
0
Capstan FG
1 1 0
0 0 1 Reel FG
1:
0:
When of the errors occurs, 2 will be
set to "1". In such a case, the VTR will be forcibly
placed into the STOP mode, the SYSTEM alarm
lamp on the front panel will light up and the buzzer
will sound.
1. When the power supply overheats.
2. When the interface between the servo and the
control abnormal.
will
Address
BIT7:
BIT5:
4-46
BITO:
7 will be HI"
will sound
BKH-201
When the ENTRY or timer RESET button is
pressed.
For BKH-2012
When the ENTRY IN, ENTRY OUT or timer
RESET button is pressed, or the TRIM
+
or -
is pressed while the TRIM or OUT
pressed.
BIT6:
the
SPLIT or RESET button pressed,
the IN, OUT, AUDIO IN or AUDIO OUT key
is pressed.
When the VTR will be forcibly placed into the STOP
mode due to an error, the buzzer will sound
continuously.
SERVO LOST LOCK
When the capstan or
lost
is detected,
will continue, and in
recordmz or editing, message LCK" will
be displayed. When the function button is pressed in
the LOCAL mode, or the remote function command
or LOST LOCK RESET command
is received in the
REMOTE mode, bit 6 will be reset to "0" and the
"'LOST LCK" display will disappear,
END-OF-TAPE
or
when the was
has designated in the take-up direction, and the
amount of tape on the S or T reel comes about 150
seconds or less before the end of the tape, bit 5 will
be set to "I", and the tape speed will decelerate to xl0
speed. The SEARCH LED on the control panel will
blink.
BVH-2000(U/C)/PS/PM
BVH-2180(U/C)/PS/PM