Sony BVH-2000, Руководство по эксплуатации и обслуживанию

Страница: 205 / 505

Height Adjustment of Guide Post 3
Loosen screw into the
post 3.
of
in
Slant Adjustment of Exit Slant Guide
21. Loosen the locking screw of the exit slant guide as-
sembly 1/8 to 1/4 tum.
22. Lightly push the
@
or
CD
side of the tape shown in
Fig. 3-75 find out the side whose RF waveform on
the tape becomes
the
Height Adjustment of Exit Slant Guide
23. Check that the tape does not curl along the guide
flange of exit slant guide. If the
the adjustment
step
Repeat to 24 becomes
as flat as possible and the tape does not along the
guide flange.
25. Finally adjust again by turning the height adjustment
screw so that the tape does not curl along the guide
flange and the RF waveform is flat.
Tighten the locking screw of the exit
and check the RF waveform
waveform
by ~ep
While confirming that the
turn the height adjustment screw of the guide post 3
so that the tape touches the lower flange of the guide
post 3.
29. Tighten the set screw which was loosened in step 19.
BVH-2000( U/C)/PS/PM
BVH-2180(U/C)/PS/PM
TAPE
SIDE
SIDE
\
HEIGHT ADJ. SCREW
SCREW
Equal ize each
clearance.
Fig. 3-75. Height Adjustment of Guide Post 3 and Slant
8nlll(~TrY\OrIT
of slant Gu ide.
Aorustment
of
Guide
w
U
Z
<t:
Z
w
f-
Z
<r
~
o(j
~
u
w
I
U
U
o
o
a::
w
0-
M