Page 20 SonicWALL TELE3 SP Administrator’s Guide
2. Enter a unique IP address from your LAN address range in the
SonicWALL LAN IP
Address
field. The SonicWALL LAN IP Address is the address assigned to the SonicWALL
LAN port and is used for management of the SonicWALL.
3. Enter your network subnet mask in the
LAN Subnet Mask
field. The
LAN Subnet Mask
tells your SonicWALL which IP addresses are on your LAN. Use the default value,
"255.255.255.0", if there are less than 254 computers on your LAN.
4. Enter the user name provided by your ISP in the
User Name
field. The user name
identifies the PPPoE client.
5. Enter the password provided by your ISP in the
Password
field. The password
authenticates the PPPoE session. This field is case sensitive.
6. Select the
Disconnect after __ Minutes of Inactivity
check box to automatically
disconnect the PPPoE connection after a specified period of inactivity. Define a maximum
number of minutes of inactivity in the
Minutes
field. This value can range from 1 to 99
minutes.
7. In the
WAN/LAN
section, select
Obtain an IP Address Automatically
if your ISP does
not provide a static IP address. Select
Use the following IP Address
if your ISP assigns
a specific IP address to you.
8. Click
Update
. Once the SonicWALL has been updated, a message confirming the update
is displayed at the bottom of the browser window. Restart the SonicWALL for these
changes to take effect.
Note
: When NAT is enabled, the SonicWALL LAN IP Address is used as the gateway address
for computers on the LAN.
When your SonicWALL has successfully established a PPPoE connection, the
Network
page
displays the SonicWALL WAN IP settings. The
WAN Gateway (Router) Address
,
SonicWALL WAN IP (NAT Public) Address
,
WAN/LAN Subnet Mask
, and
DNS Servers
are displayed.
Note
: The SonicWALL does not relay DNS settings to the LAN; you must enable and configure
the SonicWALL DHCP server or manually configure the computer DNS settings to obtain DNS
name resolution.
Restarting the SonicWALL
Once the network settings have been updated, the
Status
bar at the bottom of the browser
window displays "Restart SonicWALL for changes to take effect." Restart the SonicWALL by
clicking
Restart
. Then click
Yes
to confirm the restart and send the restart command to the
SonicWALL. The restart can take up to 90 seconds, during which time the SonicWALL is
inaccessible and all network traffic through the SonicWALL is halted.
Note
: If you change the SonicWALL LAN IP Address, you must to change the Management
Station IP address to be in the same subnet as the new LAN IP address.
Содержание TELE3 SP
Страница 1: ...SONICWALL The TELE3 SP Administrator s Guide...
Страница 204: ...Appendices Page 203 Notes...
Страница 205: ...Page 204 SonicWALL TELE3 SP Administrator s Guide...