SonicWALL TELE3 SP, Руководство администратора

Страница: 202 / 210

Appendices Page 201
Appendix H - Regulatory Compliance
The information below applies to Model/Type APL10-01F.
Federal Communications Commission (FCC) Statement
This device generates, uses, and can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, can cause harmful interference to radio
communications. This device has been tested and found to comply with the limits for a Class B
computing device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. However, there
is no guarantee that interference will not occur in a particular installation. If this equipment
does cause harmful interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the interference by
one or more of the following measures:
• Reorient or relocate the antenna.
• Increase the separation between the equipment and the receiver.
• Connect the equipment to an outlet on a different circuit from the receiver.
• Consult the dealer or an experienced radio/TV technician for help.
Caution : Modifying this equipment or using this equipment for purposes not shown in this
manual without the written consent of SonicWALL, Inc. could void the user’s authority to
operate this equipment.
FCC part 68 Telecom Information
Repair Information - According to the FCC, only the modem vendor for the SonicWALL modem
is allowed to service the modem. Contact SonicWALL Technical Support for any repairs
including the modem.
The FCC has established rules which permits this device to be directly connected to the
telephone network. If this device is malfunctioning, it may also cause harm to the telephone
network. This device should be disconnected until the source of the problem is determined and
the repair is made. If this is not done, the telephone company may temporarily disconnect
service.
The telephone company may make changes in its technical operations and procedures. If such
changes affect the compatability or use of this device, the telephone company is required to
give adequate notice of the changes. If the telephone company requests information on the
equipment connected to their lines, inform them of the following:
• Telephone number of the line connected to the device.
• The Ringer Equivalence Number (REN) located on the bottom of the device.
• The device uses an RJ11-type jack.
• The FCC Registration Number located on the bottom of the device.
For more information regarding the above statement, please contact SonicWALL, Inc. at 1160
Bordeaux Dr., Sunnyvale, CA 94089-1209 or 1-408-745-9600.