Vega 30 Router User Manual
Installing a License
Maintenance 12.4
Issue1 Revision 1
Page 238
© 2017 SAM
12.4.4 Installing a License via RollCall Control Panel
The process of adding a license to a Vega 30 unit follows the standard process for a product
with licenses administered by SAM RollCall. For more details, please see the RollCall Control
Panel User Manual.
Licenses are installed from a license zip file. This license must have been generated
specifically for the Vega 30 unit. (The unit’s MAC address is used in the license information.)
License installation via RollCall is a two-stage process:
•
Stage 1:
Add the license file to RollCall Control Panel.
•
Stage 2:
Install license on the Vega 30 unit.
These are described in the sub-sections below.
12.4.4.1
Preliminaries
•
Check the version of RollCall Control Panel being used is valid for Vega 30 units,
see Section A.15 “Software Compatibility” on page 245 for the version number.
•
Run RollCall Control Panel on a PC connected to the network.
•
Power up the Vega 30 unit and connect to the same network.
12.4.4.2
Stage 1: Add License to RollCall Control Panel
1.
From RollCall Control Panel, connect to the Vega 30 unit.
2.
Click the
Edit Licenses
icon
or click
Edit > Licenses
.
The
License Viewer
window is displayed.
3.
Click on the
Vega 10
tab.
Available licenses in RollCall are listed.
Figure 189 shows an empty
Vega 10
tab.
4.
Click
Import Licenses
.
5.
Navigate to the license zip file and select the file name.
Click
OK
.
The imported license is added to the listed licenses on the
Vega 10
tab.
Figure 189 License Viewer Window
Import licenses button