Vega 30 Router User Manual
Output Video Signal Timing
Getting Started 11.10
Issue1 Revision 1
Page 219
© 2017 SAM
12. Click
Take
to make the route.
The route is made and the Web page refreshes to show the new route to the
destination. See Figure 166.
Video input 1 is now routed to Video output 3, along with all of its embedded audio channels,
except embedded audio channels 5 and 6 in output 3, which are replaced by audio channels
3 and 4 from MADI input 1.
11.10 Output Video Signal Timing
Output signal timing is described in Section 8 “Output Video Timing - Line Sync and Offset” on
page 154. And the set up procedure is given in Section 8.4 “Setting Up Router Offset” on
page 160.
Figure 166 Source 48 Route Taken
Newly-Routed Source
Destination
Note:
Output disruption and Vega 30 Router starting:
While the Vega 30 Router unit starts up or restarts, there may be disruption to the video
outputs. This is normal: The unit starts by routing ‘1 to 1’ inputs to outputs and only adopts
the last know routing settings once the control software has successfully started up.