SMA STORAGE-67-TS-10, Инструкция по установке и эксплуатации

Страница: 43 / 52

BATTERy MONITORING SOFTWARE – BATMON 43
© SMA Solar Technology AG Subject to changes to the technical content! Version 1.1 Last updated 04/2021
11.2 Menu structure
The battery parameters are password-protected. As these parameters directly affect the battery, only certified
specialists may configure them. you can request the password from the service center.
BATTERY CELLS EVENTS PARAMETERS SYSTEM SELECTION
Charging/dischar-
ging power
Cell voltage Event logbook Battery parameters Current errors Master
Battery voltage Cell temperature Clear events Load default Version BatMon Slave
Charging/dischar-
ging current
SoC (cell) Save events
(as a PDF)
Save default Expert level
Battery temperature SoH (cell) Reset APU Start logging
Balancing mode Module voltage Firmware download
Charging cycle
(kWh)
Charging/dischar-
ging current
Communication port
Discharging cycle
(kWh)
ABO temperature
SoC (state of
charge)
SoC (state of health)
Warning - time Displayed Expert settings Functions
APU temperature data only with password
11.3 The key cell parameters
SoC – state of charge
This value indicates the percentage to which the battery has been charged. 100 % means that the battery is fully
charged. The SMA HV APU can use the parameters to determine the state of charge of a cell or battery module,
and to stop the charging process if necessary, thereby preventing overcharging. The software uses the same
function to monitor the discharging process, in order to avoid placing any unnecessary loads on the cells. Bat-
tery limit states define the points at which the system stops charging and discharging.
SoH – state of health
This value indicates how healthy the cell is. Precise monitoring allows the system to detect differences in perfor-
mance between individual cells and thus identify damaged or faulty cells. Depending on the seriousness of the
error, disconnection of the APU and STPS or a cut-off of the storage system may be necessary.