Cut halfway though C19 on the scribed line in order to allow
the piece to bend at the angle scribed in C2. Note: This piece
should be already painted with the gauge paper attached.
Glue C17, C18 & C19 to the cockpit floor and side on the
scribed marks. The rivet detail should be facing outward.
Glue C51 to the scribed marks on C18.
Cut a piece of 3/16" wood dowel to 3-3/8".
Glue C7 to the left side of the cockpit floor on the scribed
mark. Insert the dowel into C7. Place C31 and C53 over the
other end of the dowel and glue them to the scribed marks.
Cut C11 in half and Insert the first half into the holes in F8A,
F9A, C28 & C29. Push this piece all the way through until it
is flush with F9A.
Insert the other half of C11 in the holes in F8A and F9A as
shown.
Glue C11 to the outside C53 as shown
Glue C20 to C19 on the scribed marks
Stack and Glue the C42 & C47 pieces together, alternating
C42 with C47 as shown.
