Wet WF6 with ammonia/water and fit to the fillet base/fuse-
lage. Align it with WF7 and the fillet base. Glue in place then
trim as needed to match WF7.
Bevel the top edge and wet WF8 with ammonia/water. Fit to
the fuselage between WF1 and WF5. Sand as necessary for
a good fit and glue to the fillet base, fuselage and WF1 -
WF5
Use tri stock and scrap balsa to fill in the area forward of the
WF8 sheeting as shown.
Use balsa filler or auto body filler and a spoon to shape the
forward part of the wing fillet as shown. If using auto body
filler, be careful not to use too much hardener
or put on very thick layers because if it cures too quickly, the
filler could shrink and pull the base off the wing.
Remove the wing, sand the fillet to shape and blend into the
fuselage.
Repeat for the other fillet.
Tailcone:
Cut 3 pieces of 1/4" balsa one 7" and two 4"
