Wing Mounting:
Cut two pieces of 1/4" hardwood down to 2-1/2" and taper
one end of each.
Insert the dowel in the holes in the leading edge of the wing
with the tapered end facing outward.
Slide F30 over the dowel and adjust the wing holes as nec-
essary so F30 fits easily.
Epoxy the dowels into place and use F30 as a guide for the
correct position.
DO NOT GLUE F30!!
Once epoxy has cured, remove F30 and set aside for now.
Fit the wing into the wing saddle and sand as necessary for a
good fit.
Measure a line from the wingtips to the tail and center the
wing on the fuselage. Mark the location at the trailing edge of
the wing and fuselage.
Tape the wing in place.
Fit F30 inside the firewall box hole in F2 and over the wing
dowels. Epoxy F30 to F2 making sure to keep epoxy off the
wing dowels. Allow to cure
Double check the wing centering. Once sure, drill two equally
spaced holes 1-1/2" from the trailing edge into the wing and
wing hold down plate for the wing bolts. We used 1/4-20 or
10-32 nylon bolts in the prototype.
You can use thin CA to harden the bolt area.
