Glue V7 in place on the top of the stab assembly.
Lightly sand the leading and trailing edges of the stab as-
sembly until all ribs are flush.
Align V8 to the trailing edge of the stab assembly and glue in
place.
Align and glue V12 to the leading edge.
Sand the trailing and leading edge to match the contour of
the ribs.
Insert V9 and V10 in the slots in the bottom of the assembly.
Once they are straight, glue in place.
Edge glue scrap 1/16" x 4" balsa to make two 7" x 8" sheets.
Unlike the example above, the grain should run vertically.
Align the lower edge of the sheeting with the slots in V9 &
V10. Insure the sheeting covers the leading and trailing
edge. Trim as necessary and glue in place.
Repeat for the other side.
