Assemble W30 to the W31's as shown. fit the assembly onto
the W19 spar and W9 rib. Epoxy in place.
Cut & edge glue five 1/16" x 4" x 36" balsa sheets as shown
to make the top and bottom sheeting. You can Make 4 at this
time for the remaining wing sheets.
Sheet the top of the wing by starting at the leading edge and
working your way to the tailing edge.
Note: When sheeting the wing with 1/16” balsa, try to do
most of the sanding before glueing the sheeting in place.
This will keep your airframe smooth. Also, try and
choose harder balsa for the center of the wing and softer
on the edges.
Remove the wing from building board, turn over and break
tabs off of the wing ribs.
Lay the 1/8" Ply flap and W25 in place on the wing as shown.
Draw a line at the edge of these pieces on the top sheet.
Measure .55" from W26 and draw a line as shown.
Cut the top sheeting along the line that you drew in the previ-
ous steps.
Trim the rest of the sheeting as shown.
Create sheer webs from scrap 1/16" balsa. Insure the grain
runs from top to bottom - not left to right.Glue shear webs to
the spars between W13 & W18.
Use a 1/8" x 1/4" x 36" balsa stringer to make the servo
hatch supports between W13 - W14 and W9 - W10
Sand the tabs off the bottom of W19 & W20 on the right wing
half only.
Lightly sand the other ribs and spars to prepare the bottom
wing for sheeting.
