Fit F23 to the slots in F3B thru F11. The front of F23 should
glue to F2B and the top rear should be even with the top of
F11. You may need to adjust some of the notches in the for-
mers so the saddle fits without forcing it. Repeat for the other
side.
Glue F13B - F16B in place on F13A - F16A. Make sure the
pushrod holes are in the correct position (F13B thru F15B
should face toward the front).
Glue the 1/4" x 1/8" balsa stringer to the rear fuselage (to
F18) making sure to leave a 1/16" space for the sheeting.
Trim the stringer at F18.
Attached the horizontal stab assembly to the fuselage by in-
terlocking the tabs in the stab supports with the tabs in F17A
& F18A. Measure the stab to insure it is straight and tack in
place with thick CA.
Align and glue F17B and F18B in place. You may have to do
some light sanding for a good fit.
Secure the stab to the formers and fuselage using 30 min
epoxy. You can also use some tri stock to reinforce the form-
ers where they join the stab mounting tabs.
