Skye MiniMet, Руководство по установке

Страница: 9 / 58

pole over the raised centre of the base plate.
Lay out the guylines at 120 degrees from each other, and at an angle of about 45 degrees
out from the vertical pole. Undo the shackles at the end of the guylines, so that there is
enough adjustment for tightening later.
If bolting the guylines to the concrete, drill holes for the fixing bolts at the end of the
guylines and attach.
If using pegs into soft ground, drive the large 45 cm 'T' pegs into the ground at the end of
each guyline and attach.
Adjust the guyline tautness by locking the ring into place, (driving the 'T' pegs fully into the
ground if appropriate), and turning the shackles to tighten, making sure the mast pole is
vertical using the spirit level.
3.4 Erection of Mast on Roof Top
As each installation will have differing circumstances, there are no
standard instructions for this section. Please contact Skye or your
local distributor for advice or an installation quotation.
3.5 Erection of Mast on a Wall
Again each installation will have differing circumstances, but Skye
can supply T&K Brackets for this type of installation.
3.6 10 Metre Retractable Mast
The mast is made up of 5 tubular aluminium sections.
The bottom tube is 2 metres long and the other four tubes are 2.2 metres long.
The diameters have been chosen so that the tubes will telescope into each other.
6
MiniMet Installation