SIGRIST StackGuard 2, Инструкция по эксплуатации

Страница: 51 / 62

Instruction Manual StackGuard 2 System
10198E/3 45
7 Taking Out of Service/Storage
The goal of the takingout of service procedure is to prepare the photometer
properly for storage and to keep it in good condition during the storage period.
The standby power box for resetting the shut-off valves may be opened only
by trained personnel (lethal danger)!
Action
1. Switch off the power supply to the SIGAR2 and disconnect all electrical
connections.
2. Dismantle the dust emissions system.
3. Thoroughly clean the inside of all parts of the ring pipe. No corrosive or
loose dirt deposits should remain inside the ring pipe.
4. Make sure that all components are closed.
No special conditions are required for storage of the equipment, but be sure to
observe the following:

The photometer, the control unit and the valves contain electronic
components. The storage conditions must satisfy the normal requirements
for such components. In particular, the storage temperature should remain
within the -20 … +50°C range.

All components that come into contact with the medium during operation
must be kept dry and clean for an extended period of time before being put
into storage.

During storage, the photometer and accessories must be protected against
weathering, condensing moisture and aggressive gases.
Taking out of
service