SIGRIST StackGuard 2, Инструкция по эксплуатации

Страница: 49 / 62

Instruction Manual StackGuard 2 System
10198E/3 43
Message W F P Means Possible causes
Sample air x The sample air flow
is too low.
-
clogging or
contamination of
the ring pipe
system
-
main blower failure
P heat. x The heater output
is too high.
-
defective heater
Temp.sensor x One of the
temperature
sensors has failed.
-
temperature sensor
defective
CommSGBEDI x The photometer is
unable to connect
with power circuit
board SGBEDI.
-
defective SGBEDI
board
6.3 Customer service information
Whenever you have questions about SIGRIST products, please start by reading
the documentation supplied with the equipment. Also check the Errata
accompanying the documentation. These contain information that became
available subsequently.
If you do not find the answer, please contact the Service Office responsible for
your country or your region. If you don’t know where to find it, Customer
Service of SIGRIST-PHOTOMETER AG in Switzerland will gladly give you the
relevant contact address.
You will also find the current list of all SIGRIST country representatives in the
Internet at
http://www.photometer.com . Whenever you contact a SIGRIST
Service Office or Customer Service, please make sure you have the following
information at hand:
 A description of the instrument behavior and the worksteps being
performed as the problem arose.
 A description of how you proceeded when trying to solve the problem
yourself.
 Documentation on any non-SIGRIST product operated together with the
photometer or its peripheral devices.
If you have problems with the reading, please have the following additional
information at hand; you can find it in the “info“ section of the menu
structure:
Instrument data