Siemens siprotec 7SD5, Руководство пользователя, Страница: 274 / 698

2 Functions
274
7SD5 Manual
C53000-G1176-C169-1
Switching onto a
Fault To perform an instantaneous trip when the circuit breaker is manually closed onto a
dead fault, the manual closing command of the control discrepancy switch can be fed
to the device via a binary input. The overcurrent protection can then trip three-pole
without delay or with a reduced delay. It can be determined via parameter setting for
which stage(s) the rapid tripping following manually closure on to a dead fault applies
(refer also to the logic Figures 2-117, 2-118 and 2-119).
Pickup and Trip-
ping Logic The pickup signals of the individual phases (or the earth) and of the stages are linked
in such a way that both the phase information and the stage which has picked up are
indicated (Table 2-12).
In case of trip signals, the stage which resulted in the trip command is also indicated.
For single-pole tripping, the pole is identified (see also Section 2.23.1 „Pickup Logic of
the Entire Device“).
Table 2-12 Pickup signals of the single phases
Internal Indication Display Output Indication No.
I
>> PU L1
I > PU L1
I
p PU L1
I >>> PU L1
2-117
2-118
2-119
„O/C Pickup L1“ 7162
I >> PU L2
I
> PU L2
I p PU L2
I >>> PU L2
2-117
2-118
2-119
„O/C Pickup L2“ 7163
I
>> PU L3
I > PU L3
I p PU L3
I >>> PU L3
2-117
2-118
2-119
„O/C Pickup L3“ 7164
I >> PU E
I > PU E
I p PU E
I
>>> PU E
2-117
2-118
2-119
„O/C Pickup E“ 7165
I >> PU L1
I >> PU L2
I
>> PU L3
I >> PU E
2-117
2-117
2-117
2-117
„O/C PICKUP I>>“ 7191
I > PU L1
I
> PU L2
I > PU L3
I
> PU E
„O/C PICKUP I>“ 7192
I
p PU L1
I p PU L2
I
p PU L3
I p PU E
2-118
2-118
2-118
2-118
„O/C PICKUP Ip“ 7193
I >>> PU L1
I
>>> PU L2
I >>> PU L3
I >>> PU E
2-119
2-119
2-119
2-119
„I-STUB PICKUP“ 7201
(All pickups) „O/C PICKUP“ 7161
www
. ElectricalPartManuals
. com