Siemens SINUMERIK, Руководство по вводу в эксплуатацию

Страница: 720 / 736

Backing up and restoring data
4.4 Commissioning the replacement hard disk
PCU-Basesoftware (IM8)
80
Commissioning Manual, 03/2009, 6FC5397-1DP10-4BA0
4.4 Commissioning the replacement hard disk
Overview
The mechanical and electrical steps involved in replacing the PCU 50.3 hard disk are
described in:
References: Operator Components and Networking Manual
Note
The replacement hard disk is delivered without the Windows operating system and without
HMI system software.
The ServiceCenter incl. Symantec Ghost is installed at the factory on each PCU and on the
replacement hard disk.
Creating a hard disk backup (disk image)
The entire contents of hard disks can be saved as a disk image file using the Symantec
Ghost software. This "disk image" can be stored on various types of media for later
restoration of the hard disk, e.g. on CD-ROM or a network drive.
Commissioning the replacement hard disk
After installing the replacement hard disk, the Ethernet interfaces of the PCU are preset in
the following manner:
●
Ethernet 1 (Company Network) as a standard DHCP client
● Ethernet 2 (System Network) as a SINUMERIK DHCP server with the fixed IP address
192.168.214.241 and subnet screen 255.255.255.0
The PCU must therefore be disconnected from the system network before the replacement
hard disk is fitted.
To commission the hard disk, proceed as follows:
1.
Connect a PG/PC as per the recommended configurations.
2. Start the ServiceCenter and select "Restore Disk Image".
Note
If the transfer is interrupted during the "Restore" process, no consistent system is
available on the hard disk, i.e. the "Restore" process cannot be repeated because the
PCU no longer boots up.
In this event, the "Emergency Boot System" is used.
See also
Requirements (Page 71)
How to backup and restore the hard disk (Page 67)
How to create a service system for PCU (Page 61)