Layer 3 functions
9.10 PIM (IPv4)
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 06/2016, C79000-G8976-C252-11
773
The parameter has the following meaning:
Parameter
Description
Range of values / note
priority
Priority for deciding on the DR
1 ... 4294967295
The router with the highest priority becomes
the DR.
Result
The interface is a candidate for the designated router.
Further notes
You delete DR candidates with the
no ip pim dr-priority
command.
You display with the
show ip pim interface
command.
9.10.5.6
no ip pim dr-priority
Description
With this command, you delete DR candidates.
Requirement
●
The interface is not a router port.
●
You are in the Interface configuration mode
The command prompt is as follows:
cli(config-if-$$)#
Syntax
Call the command without parameter assignment:
no ip pim dr-priority
Result
The interface is not a candidate for the designated router.
Further notes
You define interface candidates for the designated router with the
ip pim dr-priority
command.
You display with the
show ip pim interface
command.