Layer 3 functions
9.5 VRRPv3 (IPv4 / IPv6)
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
660
Configuration Manual, 06/2016, C79000-G8976-C252-11
Commands relating to other topics that can be called in the VRRP3 Router configuration
mode can be found in the relevant sections.
●
If you exit the VRRP3 Router configuration mode with the
exit
command, you return to
the Interface configuration mode.
●
If you exit the VRRP3 Router configuration mode with the
end
command, you return to the
Privileged EXEC mode.
9.5.5.1
vrrp accept-mode
Description
With this command, you enable the ping function for virtual IPv6 addresses on the VRRP3
interface.
Note
This command is available only with layer 3.
Requirement
●
An IP address is assigned to the virtual router.
●
You are in the VRRP3 Interface configuration mode.
The command prompt is as follows:
cli(config-vrrp-v3-if-$$$)#
Syntax
Call up the command with the following parameters:
vrrp <vrid(1-255)> accept-mode
The parameter has the following meaning:
Parameter
Description
Range of values / note
vrid
ID of the virtual router
1 ... 255
Result
The ping function to virtual IPv6 addresses is enabled.
Further notes
You disable the ping function for virtual IPv6 addresses with the
no vrrp accept-mode
command.
You assign IP addresses to a virtual router with the
vrrp associated-ip
command.
You can display the status of the function with the
show vrrp3
or with the
show vrrp3
interface
command.