Layer 2 management protocols
8.8 MLD Snooping (IPv6)
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 06/2016, C79000-G8976-C252-11
501
Requirement
●
MLD snooping is enabled.
●
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli>
or
cli#
Syntax
Call up the command with the following parameters:
show ipv6 mld snooping statistics [Vlan <vlan id>]
The parameters have the following meaning:
Parameter
Description
Range of values / note
Vlan
Keyword for a VLAN connection
-
vlan-id
Number of the addressed VLAN
1 ... 4094
If you specify VLAN, the configuration of all VLANs is displayed.
Result
The statistics are displayed.
Further notes
You enable MLD snooping with the
ipv6 mld snooping
command.
You reset the counters to zero with the
ipv6 mld snooping clear counters
command.
8.8.2
Commands in the global configuration mode
This section describes commands that you can call up in the Global configuration mode.
In Privileged EXEC mode, enter the
configure terminal
command to change to this mode.
Commands relating to other topics that can be called in the Global configuration mode can
be found in the relevant sections.
You exit the Global configuration mode with the
end
or
exit
command and are then in the
Privileged EXEC mode again.
8.8.2.1
ipv6 mld join ratelimit
Description
With this command, you define the maximum number of Join messages on the device.