LITHOSTAR MODULARIS
4 - 5
Siemens AG
SPL1-130.840.02
Page 5 of 34
MODULARIS Uro Plus
Medical Solutions
Rev. 03
04.05
CS PS 24
Installing the shock wave head
4
•
Shorten both hoses at the shock wave head corresponding to the dimensions in Fig. 5.
•
Check that the spring-mounted temperature sensor (T/Fig. 6) is seated correctly in the
groove.
•
Insert the air suction hose centrally through the shock wave head (L/Fig. 9).
•
Install the new shock wave head from above and insert the water hoses;
when doing this ensure that
the hose marked in red (R/Fig. 7) is located next to the
high-voltage connector and that the air suction hose underneath the shock wave
head is neither kinked nor caught in the shock wave head.
•
Attach the shock wave head with the Allen screws (O/Fig. 7) visible through the opening.
•
Push the high-voltage plug as far up as possible, until the openings (O/Fig. 7) are
covered again.
•
Reattach the screw (SL/Fig. 7) with the protective conductor.
•
Retighten the 2 Allen screws (U/Fig. 4) underneath the shock wave head.
•
Place the iso-center phantom on top so that it is flush and secure it with the four screws
(V/Fig. 3) (use an Allen key with a guide pin for this purpose).
Fig. 5
Fig. 6
Fig. 7
48
±
1 mm
SL
R
O
T
