13
8020216/19YN/V3-0/2020-12| SICK
O P E R A T I N G I N S T R U C T I O N S | DUSTHUNTER SP100 Ex-3K
Subject to change without notice
FOR YOUR SAFETY
2
WARNING:
Health hazard due to hot sample gases and components
Risk of skin burns through contact with hot sample gases and hot components
▸
In systems with high temperatures, work on the duct or hot assemblies should only
be carried out when the system is shut down.
▸
Keep fitted valves and seals closed until cooled down.
▸
Allow enclosure parts or surfaces involved to cool down before touching.
When work is necessary on hot assemblies:
▸
Before opening gas paths or touching surfaces: Take suitable protective measures
(e.g. personal protective equipment).
▸
Use heat-resistant tools.
▸
Keep disassembled hot components away from electrical components and lines.
Allow to cool down at a protected place.
WARNING:
Hazard through escaping gas or bursting components due to overpressure in
the system
High process pressure can damage components and lead to personal injury through
bursting components or escaping health-endangering gas.
▸
Only use components designed for the process pressure in the application (
▸
Only carry out installation and maintenance of the device when the system is
switched off.
NOTICE:
Danger to operational safety at high temperatures
The device can be damaged by high temperatures. The operator must take suitable
measures to ensure the enclosure temperature does not exceed 70 °C.
▸
Avoid direct sunlight. If necessary, take measures to protect against the weather.
▸
If necessary, insulate the stack to prevent high temperatures.
NOTICE:
Danger to operational safety in the event of visible damage
Operating the measuring system with visible damage can further damage the measuring
system or make it a source of danger.
▸
Check the components of the measuring system for external damage after each
transport.
▸
If there is visible damage, do not put the measuring system into operation but send it
in for repair (
see “Return delivery”, page 123
).
