Shimadzu MOC-120H, Инструкция по эксплуатации

Страница: 38 / 76

26
7) Specifying settings for PREDICT (Predictive measuring) mode
Predictive measuring mode is used to predict the change in moisture content and calculate the predicted
final measurement before drying has been completed. Thus measuring time can be saved. Note that some
materials have properties which make it difficult to obtain accurate predictions. Measurements in preparatory
measuring mode must be performed to check the precision of measurement and determine the possible
effectiveness of Predictive Measurement in terms of shortening the measuring time.
Display Key(s) used Operating instructions
With the display of the weight in grams, press the
CONDITION
key.
If a password has been specified, the message ‘PASS’ will be
displayed to indicate that the password should be entered. Use
the
key, key and
ENTER
key to enter the password. Follow
the instructions under step
7
in “9-2-7 Specifying a password” to
set or delete a password.
The ‘CONDITIONS’ display area will begin to flash. Press the
SELECT
key repeatedly until ‘MODE’ begins to flash.
With the ‘MODE’ display flashing, press the
ENTER
key. This will
cause control to shift to measuring mode selection and for the
currently specified measuring mode to begin flashing.
Press the
SELECT
key repeatedly until ‘PRD’ begins to flash.
* If ‘PRD’ is already flashing, then proceed directly on to the next
step.
When ‘PRD’ flashes, press the
ENTER
key. ‘PRD’ will then change
from a flashing to a constantly lit display and you will next be
required to specify the predicted value convergence range
settings (see “
Predicted value convergence range”). The
current setting for the predicted value convergence range will
begin to flash.
Press the key or key to select the desired automatic
ending condition. Automatic ending condition may be specified in
0.01-percent increments anywhere in a range from 0.1 to 9.9
percent. Note that here a value of 0.5% has been selected.
When the desired automatic ending condition has been selected,
press the
ENTER
key. The specified setting will change from a
flashing to a constantly lit display, and ‘MODE’ will begin to flash.
If you wish to specify other measuring conditions settings, press
the
SELECT
key to select the menu.
To exit from specifying measuring conditions settings, press the
CONDITION
key instead.
Step
1
2
3
4
5
6
7
8
9
CONDITION
ENTER
SELECT
SELECT
ENTER
ENTER
SELECT
CONDITION
Note: Read Section 12 before use of this part.
SALES & TECHNICAL SUPPORT
QAQC LAB www.qclabequipment.com TEL (804) 318-3686