Shimadzu MOC-120H, Инструкция по эксплуатации

Страница: 31 / 76

19
2) Specifying settings for TIME (Standard drying & Timed ending) mode
In this mode, the measuring time is specified beforehand. When the specified measuring time is reached,
measuring is ended.
Measuring time may be specified in 1-minute increments anywhere in a range from 1 to 240 minutes or
measuring may be specified to be performed over a continuous period of 12 hours.
Display Key(s) used Operating instructions
With the display of the weight in grams, press the
CONDITION
key.
If a password has been specified, the message ‘PASS’ will be
displayed to indicate that the password should be entered. Use
the
key, key and
ENTER
key to enter the password. Follow
the instructions under step
7
in “9-2-7 Specifying a password” to
set or delete a password.
The ‘CONDITIONS’ display area will begin to flash. Press the
SELECT
key until ‘MODE’ begins to flash.
With the ‘MODE’ display flashing, press the
ENTER
key. This will
cause control to shift to measuring mode selection and for the
currently specified measuring mode to begin flashing.
Press the
SELECT
key repeatedly until ‘TIM’ begins to flash.
* If ‘TIM’ is already flashing, then proceed directly on to the next
step.
When ‘TIM’ flashes, press the
ENTER
key. This will cause the
measuring time settings to become active and the currently
specified measuring time to flash.
Press the key or key to select the desired measuring time.
Note that here a time of ‘30 minutes’ is specified.
When the desired measuring time flashes, press the
ENTER
key. The
specified measuring time will change from a flashing to a
constantly lit display and
‘MODE’ will begin to flash instead.
If you wish to specify other measuring conditions settings, press
the
SELECT
key to select the menu. To exit from specifying measuring
conditions settings, press the
CONDITION
key instead.
Step
1
2
3
4
5
6
7
8
9
CONDITION
ENTER
ENTER
SELECT
CONDITION
SELECT
SELECT
ENTER
SALES & TECHNICAL SUPPORT
QAQC LAB www.qclabequipment.com TEL (804) 318-3686