Shimadzu MOC-120H, Инструкция по эксплуатации

Страница: 24 / 76

12
7. How to Conduct Measurements
Before beginning measurement, check to make sure that there is nothing remaining in the sample
pan. Also be sure that all parts of the main unit are firmly fixed into place and be sure that the
heater lid has been closed firmly before starting to perform measurements.
Also be sure to check on a regular basis that the main unit is level and readjust the height adjust-
ment legs if necessary. (See “6. Assembly and Installation of Main Unit” on p. 8 for instructions on
how to do so.)
Display
* Display will show default settings at the
time of shipment. (See p. 17, “8-2-1
Selecting the CONDITIONS (Measuring
conditions storage area)”.)
Operating instructions
1
Turn on the power switch
* Once the power voltage setting has been spcified (Step
~
in 6.), when the
power is turned on for the second or subsequent times, a tone will sound,
the display will light up with all items lit, the display will change to display
‘CHE4’, ‘CHE3’, … , ‘CHE0’ while the currently specified power setting is
displayed, and then a tone will sound again and the display will change to
weight reading display mode.
* Note: It is recommended that you always turn on about half an hour before
use in order to obtain consistent measurements.
2
Specifying settings
When performing measurements for the first time or when you wish to
change current settings before measuring, you should specify the settings
required for measuring at this time. (See “8. Specifying Measuring
Conditions” on p. 15 and “9. Menu settings” on p. 29 for instructions on how
to do so.)
3
Placing the sample pan in the tester
Open the heater lid, place the sample pan on the handler, and place the
handler into the tester, being sure when you do so that the grooves of the
handler fit smoothly over the projection located at the rear of the wind shield.
* If you have already place the sample pan and handler into place as described in
“6. Assembly and Installation of Main Unit”, then proceed directly to the next
step.
* When using an aluminum foil sheet or other wrapping material because of the
nature of the sample being measured, place it on top of the sample pan.
SALES & TECHNICAL SUPPORT
QAQC LAB www.qclabequipment.com TEL (804) 318-3686