Shimadzu MOC-120H, Инструкция по эксплуатации

Страница: 33 / 76

21
Display Key(s) used Operating instructions
Pressing the
SELECT
key will cause the units to switch between
minutes (‘min’) and a percentage (‘%’). Press the
SELECT
key until the
desired units are displayed.
When the desired unit flashes, press the
ENTER
key. This will cause
control to shift to the specification of the ending conditions and the
numerical field begins to flash.
Press the key or key to set the value of the desired ending
condition. Note that here the timed ending of 20 minutes has been
specified.
When the desired ending condition flashes, press the
ENTER
key.
The rapid drying temperature that was previously specified will
begin to flash.
(Default setting is 180°C for 'TT' mode, 200°C for 'ST' mode.)
Press the key or key to set the desired rapid drying
temperature. Note that here a temperature of 140°C is set.
When the desired temperature flashes, press the
ENTER
key. The
specified ending conditions will then change from flashing to a
constantly lit display and
‘MODE’ will begin to flash.
If you wish to specify other measuring conditions settings, press
the
SELECT
key to select the menu. To exit from specifying measuring
conditions settings, press the
CONDITION
key instead.
Step
9
0
A
B
C
D
E
SELECT
ENTER
SELECT
CONDITION
ENTER
ENTER
SALES & TECHNICAL SUPPORT
QAQC LAB www.qclabequipment.com TEL (804) 318-3686