IMPORTANT SAFETY INSTRUCTIONS
GB-3
Do not use plastic containers for microwaving if the
oven is still hot from using the
GRILL
mode,
CONVECTION
mode,
DUAL
mode,
EXPRESS
COOK
,
POTATO
and
INSTANT ACTION
operations, because they may melt. Plastic
containers must not be used during above modes
unless the container manufacturer says they are
suitable.
NOTE:
If you are unsure how to connect your oven, please
consult an authorised, qualified electrician.
Neither the manufacturer nor the dealer can accept
any liability for damage to the oven or personal
injury resulting from failure to observe the correct
electrical connection procedure.
Water vapour or drops may occasionally form on
the oven walls or around the door seals and
sealing surfaces. This is a normal occurrence and is
not an indication of microwave leakage or a
malfunction.
To promote trouble-free use of your oven
and avoid damage.
Never operate the oven when it is empty except
where recommended in the operation manual, see
Page GB-8. Doing so may damage the oven.
When using a browning dish or self-heating material,
always place a heat-resistant insulator such as a porcelain
plate under it to prevent damage to the turntable and
turntable support due to heat stress. The preheating
time specified in the dishes instructions must not be
exceeded.
Do not use metal utensils, which reflect microwaves
and may cause electrical arcing. Do not put cans
in the oven.
Use only the turntable and the turntable support
designed for this oven. Do not operate the oven
without the turntable.
Do not place anything on the outer cabinet during
operation.
4. The oven door may become hot during
cooking. Place or mount the oven so that
the bottom of the oven is 85 cm or more
above the floor. Keep children away
from the door to prevent them burning
themselves.
5. Do not allow the power supply cord to
run over any hot or sharp surfaces,
such as the hot air vent area at the top
rear of the oven.
6.
Ensure there is a minimum of free space above
the oven of 13 cm.
7.
Securely connect the plug of the oven to a
standard ear thed (grounded) household
electrical outlet.
INSTALLATION
1.
Remove all packing materials from the inside of
the oven cavity. Discard the loose polythene
sheet from between the door and cavity.
Remove the feature sticker, if attached, from the
outside of the door.
2.
Check the oven carefully for any signs of
damage.
3.
Place the oven on a flat, level surface strong
enough to support the oven’s weight plus the
heaviest item likely to be cooked.
Remove this film.
13 cm
Wawa-R969, R96ST-A.qxd 8/31/06 12:13 PM Page 4
