Sencore VB330, Руководство пользователя

Страница: 93 / 203

Port: The port to forward to. The combination of IP address and port fully describes
the destination address.
TTL:
The Time-To-Live flagging of the relayed signal. The default value is 64.
Timeout: The relaying period in minutes. If the value 0 is selected, no timeout applies,
and relaying will continue until it is stopped manually.
Encapsulation: The encapsulation format of the relayed stream. UDP or RTP may be selected.
Relay via interface: The available interfaces for forwarding the stream are listed.
When mode Record or Trigger recording has been selected the options are:
Record and trigger options
Rec timeout: The maximum recording time in seconds. This setting enables the user to limit
recordings of low-bitrate streams.
Rec size: The total file size of the recording. When in alarm trigger mode the resulting
recording will consist of a fixed sized portion of data before the alarm is raised
and the remaining recording from data after the trigger occurred.
Protect: When in alarm trigger mode the user may select to protect a recording from
being overwritten due to a new alarm occurrence. The user may select between
‘Never overwrite’, ‘Do not protect’, ‘30 seconds’, ‘60 seconds’ and ‘5 minutes’.
Alarm trigger 1–3: Select a maximum of three different alarms that should trigger recording. Note
that a recording will start upon a transition from status
ok to status alarm . Alarms
that have been disabled in the Alarm — Alarm setup view will be shown in
brackets – these will never trigger a recording.
The maximum recording size depends on the amount of free disk on the probe, up to a maximum of
750 Mbyte.
VB3xx 10G Probe User’s Manual version 5.3 93