Sencore VB330, Руководство пользователя

Страница: 23 / 203

Menu: /ewe/probe/core/setup/ethernet/
==============================================================================
<0> Back
<9> Exit
<1> ethStatusDoc
------------------------------------------------------------------------------
<A> data_dhcp
- false SFP+ B port (eth0) DHCP
<B> data_ipa - 10.0.30.101 SFP+ B port (eth0) IP address
<C> data_mask - 255.255.255.0 SFP+ B port (eth0) netmask
<D> data_gateway - 10.0.30.1 SFP+ B port (eth0) IPv4 GW
<E> data_management - true SFP+ B port (eth0) web-server
<F> dhcp - false Management port (eth1) DHCP
<G> ipaddress - 10.0.20.101 Management port (eth1) IP address
<H> netmask - 255.255.255.0 Management port (eth1) netmask
<I> mm_gateway - 10.0.20.1 Management port (eth1) IPv4 GW
<J> management - true Management port (eth1) web-server
<K> gateway_interface - eth1 Force default interface
<L> dns_server - 208.67.222.222 DNS Server
<M> reboot - false
------------------------------------------------------------------------------
Figure 4.8: Text-based menu displayed when connecting over USB
•
Stop bits: 1
•
Flow control: None
Press
Enter
a few times to bring up the login prompt. Log in using the user name
admin
and the
password elvis (this password can be changed in the Setup – Security view).
A simple text based menu system like the one in figure 4.8 should now be displayed. To change a
setting, press the appropriate character from the left-most column, enter the new value and confirm by
pressing
Enter
. If DHCP is enabled, you can find the currently assigned IP address by selecting the
ethStatusDoc option.
The 10G Probe is equipped with two network interfaces called management (or eth1) and data/video
SFP+ B (or eth0). It is necessary to configure at least one of these interfaces from the terminal and
then do the rest of the setup from a web browser. Depending on the installed license, an additional data
interface, labelled data2 (eth2), may also be available.
The 10G Probe supports both in-band management (i.e. using eth0 for both data/video and management)
and separate management (i.e. using eth1 for management). In any case make sure that the subnets
configured for eth0 and eth1 do not overlap – otherwise the probe will not work properly. Note that if IP
addresses for eth0 and eth1 are configured so that the subnets overlap, the IP address of one of the
ports will be automatically set to 1.1.1.1 by the 10G Probe.
To configure the management interface, edit values for ipaddress, netmask and mm_gateway or enable
dhcp instead.
VB3xx 10G Probe User’s Manual version 5.3 23