Sega HOUSE OF THE DEAD 4 SUPER DELUXE, Руководство пользователя

Страница: 13 / 148

10
3.5. Precautions regarding installation and location
Perform the assembly by following the procedure herein stated. Failure to comply with
the instructions, for example, inserting the plug into an outlet at a stage not mentioned in
this manual can cause an electric shock
Assembling should be performed as per this manual. Since this is a complex machine,
erroneous assembling can cause damage to the machine, or malfunction to occur.
Do not attempt to complete this work alone, a minimum of 2 people are required.
QUALIFIED SERVICE PERSONNEL should only carry out assembly work.
This product is an indoor game machine. Do not install it outside. Even indoors, avoid
installing in places mentioned below so as not to cause a fire, electric shock, injury and/or
malfunction.
Places subject to rain or water leakage, or places subject to high humidity in the
proximity of an indoor swimming pool and or shower, etc.
Places subject to direct sunlight, or places subject to high temperatures in the proximity
of heating units, etc.
Places filled with inflammable gas or vicinity of highly inflammable/volatile chemicals or
hazardous matter.
Dusty places.
Sloped surfaces.
Places subject to any type of violent impact.
Vicinity of anti-disaster facilities such as fire exits and fire extinguishers.
The operating (ambient) temperature range is from 5
℃
to 30
℃
.
3.5.1. Limitations of usage
Be sure to check the Electrical Specifications. Ensure that this product is compatible with
the location's power supply, voltage and frequency requirements. A plate describing
Electrical Specifications is attached to the product. Non-compliance with the Electrical
Specifications can cause a fire and electric shock.
This product requires a breaker and earth mechanism as part of the location facilities.
Using the product without these can cause a fire and electric shock.
Ensure that the indoor wiring for the power supply is rated at 15A or higher (AC single
phase 100V
̃
120V area), and 7A or higher (AC 220V
～
240V area). Non-compliance
with the Electrical Specifications can cause a fire and electric shock.
Be sure to use an independent power supply equipped with a surgesuppressor.
Using a power supply without a surge-suppressor can cause an outbreak of fire if a power
surge occurs.
Putting many loads on one electrical outlet can cause generation of heat and a fire
resulting from overload.
When using an extension cord, ensure that the cord is rated at 15A or higher (AC
100V
̃
120V area) and 7A or higher (AC 220V
～
240V area)
Using a cord rated lower than the specified rating can cause a fire and electric shock