82
9.2. Replacing the sensor unit
①
Follow steps
①
-
③
above of the microswitch replacement procedure.
You will now have removed cover L.
②
Undo the connector and remove the
sensor unit.
Undo the connector.
③
Attach the new sensor unit and fit it back in place inside the Control Unit (Gun).
Then operate all buttons on the gun and confirm that the microswitch turns ON/OFF before putting covers L
and R back together.
Do not tighten the screws too tightly when reattaching the covers.
④
Perform a targeting test as described in the chapter on "Test Mode."
Содержание HOUSE OF THE DEAD 4 SUPER DELUXE
