37
3.11. Troubleshooting
•
These procedures should only be carried out by QUALIFIED SERVICE
PERSONNEL.
If a problem occurs, first check the wiring connections.
PROBLEMS CAUSE
COUNTERMEASURES
The power is not ON.
Firmly insert the plug into the outlet.
Incorrect power source/voltage.
Make sure that the power supply/voltage
are correct.
When the main
switch is turned ON,
the machine is not
activated.
AC Unit CIRCUIT PROTECTION
DEVICE (i.e.; fuse) was activated due
to an instantaneous over current.
First, remove the cause of over current
and reinstate the circuit protection device
to its original status.
Then identify the cause of the fault on the
item, which caused the over current, & fix.
The colour image on
the screen is
incorrect.
Incorrect monitor adjustment.
Make appropriate adjustments.
The on-screen image
of the monitor sways
and/or shrinks.
The power source and voltage are not
correct.
Make sure that the power supply and
voltage are correct.
Sound volume adjustment is not
correct.
Adjust the volume setting on the VTS
bracket.
Malfunctioning BD and Amp.
Perform Sound Test to check it.
Connector connection is incorrect.
Check connector connection from Base to
Speaker.
Sound is not emitted.
VR malfunctioning.
Replace the V.R.
Sighting is inaccurate due to
environmental conditions, etc.
Adjust the gun sighting alignment.
Micro switch malfunctioning.
Replace the micro switch.
Controller operation
is not satisfactory.
Sensor BD is malfunctioning.
Replace the Sensor BD.
Fluorescent lamp needs replacement.
Replace the fluorescent lamp.
The fluorescent lamp
does not light up.
The connector is disconnected.
Check connector connections in the
billboard case.
The lamp needs replacement.
Replace the lamp.
The LEADER lamp
does not light up.
The connector is disconnected.
Check connector connections in the
billboard case.
Communication cable is disconnected.
Connect the cable.
Cable connections are not correct.
Connect the cable correctly.
Interactive play is not
possible.
Settings for communication play are not
correct.
Ensure that GAME ASSIGNMENTS
settings are correct.
Содержание HOUSE OF THE DEAD 4 SUPER DELUXE
