Sega HOUSE OF THE DEAD 4 SUPER DELUXE, Руководство пользователя

Страница: 81 / 148

78
9. Gun control unit
In order to prevent any electric shocks or short circuits, be sure to turn the power off
before performing any work that involves touching the interior parts of the product.
Be careful not to damage the wires. Damaged wires may cause electric shocks or
short circuits, or present a risk of fire.
Be very careful when soldering. Handling a soldering iron carelessly may result in a
fire or burns.
When securing the plastic-made parts, do not excessively fasten screws and nuts.
Failure to do this may damage the parts, and fragments resulting from damage may
cause injury.
When reassembling the Control Unit (Gun), be sure to check the connecting portion
and the trigger, etc. If the reassembly work is insufficient and/or incorrect, fingers
may be caught and result in injury.
Make sure that there is no gap when attaching cover L and R. A gap or crack may
trap hands or fingers and lead to injury.
Do not cut the tie belt securing the wires in the Control Unit (Gun).
Cutting the tie belt may cause malfunctioning of the wire connection. If you cut the tie
belt when replacing the wire etc., be sure to secure the wires using a new tie belt as
before.
After taking the Control Unit (Gun) apart, always use "Tightening Adhesive" (part
number: 090-0012). Apply an appropriate amount to the screw and then tighten it up.
If you do not use "Tightening Adhesive" there is a risk of looseness or the Control
Unit (Gun) coming apart.
Only use the tightening adhesive specified by this manual. Using any other
"Tightening Adhesive" may cause a chemical reaction that renders the screws
useless or damage the surface of the Control Unit (Gun).
Follow these directions carefully to avoid damaging or losing small parts.
After exchanging any parts, always enter Test Mode and adjust/check the Control
Unit (Gun).