Sea Recovery Aqua Whisper DX 1400-2, Руководство пользователя

Страница: 127 / 226

Aqua Whisper DX Modular 450-1800
Page 8-3
Maintenance
COMPONENT MAINTENANCE REQUIRED TIME INTERVAL CONTINUOUS TIME INTERVAL INTERMITTENT DUTY
Sea Strainer Inspect & Clean Screen &
Housing weekly 100 hours
Plankton Filter Inspect & clean weekly 100 hours
Multi Media Filter Back wash & Rinse when pressure drops 20 PSI (1.37
BAR) across the filter
Pre-filter Replace element(s) Low Pressure <10 psi (0.68 BAR) Low Pressure <10 psi (0.68 BAR)
Oil/water Separator Replace element Low Pressure <10 psi (0.68 BAR) Low Pressure <10 psi (0.68 BAR)
Std HP Pump
Opt HP Pump
Change Oil
Replace Seal Kit
Replace Valve Kit
Internal Service
500 hrs
2000 hrs
2000 hrs
Approxi 8000 hrs
500 hrs
2000 hrs
2000 hrs
R. O. Membrane Clean Element When production or salt rejection
decreases by 10%
Salinity Probe Clean Probes Annually Annually
Charcoal Filter Replace Element 3 months 3 months
pH Neutralizing
Cartridge Replace Cartridge clean quartz
sleeve when calcium carbonate granules
are depleted
UV Sterilizer Replace lamp & 2000 Hours 2000 Hours
Fresh Water Flush
Charcoal Element Replace Element 3 months 3 months
cavitation of the Booster Pump and High
Pressure Pump resulting in continual
system shut down due to low feed water
flow and pressure. The resulting failure
of the system to remain in operation is
attributed to improper installation, is the
liability of the installer, and is not covered
by the Sea Recovery warranty.
CAUTION
: If the thru-hull fitting has been
placed in a position on the underside of
the hull that allows air to continually enter
the thru-hull fitting, this will cause the
system to continually shut down due to
loss of feed water. The resulting failure
of the system to remain in operation is
attributed to improper installation, is the
liability of the installer, and is not covered
by the Sea Recovery warranty.
CAUTION : The Sea Recovery System
must not be tied into another existing
auxiliary water line already supplying
another accessory on the boat. Using
one Thru Hull fitting for other equipment
will cause the Sea Recovery System to
draw air or cavitate leading to continual
system shut down. The resulting failure
of the system to remain in operation is
attributed to improper installation, is the
liability of the installer, and is not covered
by the Sea Recovery warranty.
CAUTION
: If the Sea Recovery
System is connected to a Sea Chest or
Stand Up Pipe, do not plumb the Sea
Recovery System feed line to the “top”
of the Sea Chest or Stand Up Pipe. If
plumbed into the top of these feed water
arrangements, the Sea Recovery System
will experience continual shut down due
to air inducement into the system. The
resulting failure of the system to remain
in operation is attributed to improper
installation, is the liability of the installer,
Maintenance Timetable: